Machine Details Page

Overview

To navigate to this page click on a machine in the Dashboard view. In this page further information specific to a unique machine can be found. The following sections elaborate on the information found within each tab, on the machine details page.

Machine Data

This is about machine data

Machine Utilization

The machine utilization page provides detailed information on how a machine has been used. The page is broken down into four main sections:

• Map area
• Settings area
• Chart area
• Table area

each area is described in the following subsections.

Map area

The map area gives an overview of where the machine was physically located when it was last in contact with the Dyn@Link server.

Settings area

In the settings area, you can select the length of time to generate the graph for. Your are able to select one of the following ranges of time:

• 1 day
• 1 week
• 1 month

Once you have selected a range of time, you are able to select the start for this range of time. For example if you select 1 week, then 24/9/2019 you will get a graph that shows the utilization data for an entire week starting on 24/9/2019.

Chart area

The chart area shows two pi charts, side by side. On the left side, the chart shows the utilization over the time period that you selected in the settings area. On the right side, the chart shows the utilization of the machine over the lifetime of the machine. In the upper right of each chart there is a small symbol with three lines, if clicked this allows you to download the graphic.

Depending on what type of machine you are using the charts will change slightly. To understand what each section of the chart represents please consult the corresponding section below.

Pavers

When a paver has been selected the graph will show three sections, titled:

• Static/Transport
• Idle
• Paving

In the following sections you can see how each of these values is calculated.

Paving

For a paver to be considered paving, it must meet the following conditions:

• Driving forward
• Not in Transport mode
• Vibration or tamper is active
• Screed is set to floating

CA Rollers

When a CA roller has been selected the graph will show three sections, titled:

• Static/Transport
• Idle
• Vibrating

In the following sections you can see how each of these values is calculated.

CC Rollers

When a CA roller has been selected the graph will show three sections, titled:

• Static/Transport
• Idle
• Vibrating